Protection Film Structure Thick 10 cm

Description

Protection Film is a high-quality self-adhesive plastic protective film deliverable in 2 different colours: transparent or textured black.

The universal films are used to protect parts against mechanical influences. What we have in mind here are parts susceptible to stone-chip damage, but also parts that can be damaged by shoes, for example.
The textured finish of Protection Film can be used not only for protection, but as marking and as an anti-slip at the various points of entry.

Protection Film is easy to apply. It can be applied dry or wet by using the Application Activator. The film can be easily repositioned and does not stick until the pressure sensitive layer of glue is firmly rubbed with the special spatula (Blade for Striping).

Because Protection Film is made of cast vinyl, the product does not shrink and it can be easily and permanently fitted to the shape of the surface.

Due to its packaging on 10 metre rolls or in A4 format, Protection Film is easy to cut to any desired shape of protection. In addition to these types of packaging, we provide a pre-cut floor piece for the door (Door Sill Protectors).

This means you do not need a large stock of pre-cut shapes, which are often needed for just one part.

Properties

• Original OEM.
• Wear resistant.
• Universally applicable.
• Simple to apply.
• Transparent finish is just about invisible.

Instructions for use

• Surface preparation: The surface must be clean, dry and free of grease. Clean surfaces with Innotec Multisol or Innotec Seal and Bond Remover.
• Application method: Cut the required film to size with scissors or knife. Dry application: Lay the film and press on or wipe over with a plastic spatula and cloth. Wet application: Spray Innotec Application Activator liberally over the place to be covered with the film. Then place and position the film. Remove any air and Application Activator present under the film with a plastic spatula (e.g. Blade for Striping) and a clean, dry Multi Wipe.

Technical information

• Base: Vinyl foil
• Dimensions: 10 cm x 0,32 mm x 10 m
• Adhesive strength: After 20 hours / 90°C: 500 N/m²
  After 24 hours / 90°C: 530 N/m²
  After 20 hours / 180°C: 600 N/m²
• Temperature resistance: -40°C to +95°C
• UV resistance: Good
• Water resistance: Good
• Solvent resistance: Moderate
• Application conditions: +10°C to +50°C
• Type of surface: On almost every smooth surface
• Surface preparation: The surface must be clean, dry and free of grease. Clean surfaces with Innotec Multisol or Innotec Seal and Bond Remover.
• Application method: Cut the required film to size with scissors or knife. Dry application: Lay the film and press on or wipe over with a plastic spatula and cloth. Wet application: Spray Innotec Application Activator liberally over the place to be covered with the film. Then place and position the film. Remove any air and Application Activator present under the film with a plastic spatula (e.g. Blade for Striping) and a clean, dry Multi Wipe.
• Correction time: 5 minutes
• Cleaning of hands: With Innotec Power Scrubs or with Innotec Safe Hand Clean Plus and water
• Shelf life: 2 years in original, unopened packaging
• Storage conditions: Store cool and dry, at a temperature between +5°C and 20°C
• Type of batchcode: F
• EAN Code: 5400563026250